Please wait while the page loads...

2013 Lexus IS 250C Check Engine Light

If the check engine light in your 2013 Lexus IS 250C starts flashing, that means that the problem needs swift attention and your Lexus should be brought in hastily. A flashing light indicates that the problem is dangerous and if not taken care of hastily may result in roomy wear and tear to the vehicle. This blinking light usually implies a adequate engine misfire allowing unburned fuel to be discharged into the exhaust system. There it can rapidly surge the temperature of the catalytic converter to a point where damage is attainable, requiring an costly repair. Some owners ask if spark plugs cause the check engine light to flash? This can solely be the cause. A bad, common or dirty spark plug can cause the engine to misfire. If your check engine light is shining, please contact our team of automotive consultants at Plaza Lexus expeditiously by calling 3145823688. If the problem is ignored or you continue to commute, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a extraordinarily expensive repair.

Check Engine Light Service 2013 Lexus IS 250C

What do you do when you’re driving along in your Lexus IS 250C and hastily, a yellow light flashes on your dash and says "Check Engine". If you’re like most Lexus owners, your heart sinks a scant because you have scant idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2013 Lexus IS 250C checked as soon as accessible. Ignoring that warning could end up causing considerable break to lavish engine components.

When your 2013 Lexus IS 250C's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t careful, a computer turns on your check engine light. This amber or yellow light is ordinarily labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electronic observe tool that is used by our Lexus auto repair mechanics at Plaza Lexus. There are also a number of relatively inexpensive code readers that are designed for do-it-yourselfers, should you designate that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an persuasive professional to select the issue and repair it.

Will the check engine light reset itself?

The check engine light on your 2013 Lexus IS 250C will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going factual, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2013 Lexus IS 250C light will go off after about 20-40 miles. If you drive over that deposit and the light is still on, you will need to bring it in to Plaza Lexus so the light and code can be double-checked and reset.

How much does it cost to get the engine light checked?

The check engine light warns of issues ranging from a gas cap that's not appropriately tightened to a more treacherous failure like a detrimental catalytic converter or a problem with one of the car's oxygen sensors, so it conspicuous to get the constitutional code reading and diagnosis. The intermediate cost for a check engine light diagnosis & testing is normally between $88 and $111. The conspicuous news, Plaza Lexus offers complimentary multi-point inspections and free diagnostics, in most cases, to help determine the cause of your check engine light.

2013 Lexus IS 250C Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard suddenly illuminates, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just extra name for check engine light codes. These are automotive computer codes stored by the ECM, also common as the OBD (on-board computer diagnostic system) in your IS 250C. There are hundreds of clear codes that your check engine light can represent. While that sounds daunting, with a little patience, tackling preeminent diagnostics will give you beautiful knowledge about your vehicle and will also allow that Check Engine Light to do what it is really supposed to do: be your guide. Unfortunately, pronounced and helpful vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of authentic OBD codes, there are also hundreds of authentic reasons for the light, including:

  • Computer output circuit issues
  • Bad Spark Plugs
  • Old Battery
  • Emissions controls issues
  • Transmission issues
  • Fuel and air metering systems problems
  • O2 Sensor
  • Loose Gas Cap or Missing Gas Cap
  • Ignition system faults

This is why it is laborious for someone who does not have several of automotive knowledge to not assume what a code means. When your check engine light comes on, you should get it checked out abruptly by a certified Lexus mechanic. Call Plaza Lexus at 3145823688 straightaway or schedule your check engine light service online today! If the engine light comes on due to a risky concern, you risk destructive your car further by not repairing the issue right away.

What could cause the check engine light to come on in a 2013 Lexus IS 250C?

When your check engine light comes on, this could be as conspicuous as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a treacherous problem that could cause treacherous damage to your engine and come with a curious repair bill. Depending on your make and model, the check engine light will illuminate or blink. A legitimate glow typically means something fewer treacherous but a flashing check engine light implies that your vehicle’s engine is in treacherous trouble and service is decisive instantly. If your check engine light is flashing in your 2013 Lexus IS 250C, we notably advocate not to drive the vehicle and schedule Lexus service today. Below is a list of the most prevalent reasons your check engine light can come on:

  • New Spark Plugs or Plug Wires are imperative for your 2013 Lexus IS 250C. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or erstwhile, you will experience scanty performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, large to more costly repairs.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2013 Lexus IS 250C’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is frequently caused by neglected maintenance, which is why Plaza Lexus offers a complimentary multi-point inspection with every Lexus service. If you have an issue with your catalytic converter and don't get it repaired, your 2013 Lexus IS 250C will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause alternative problems from overheating.
  • One of the most affectionate and countless cause is that your 2013 Lexus IS 250C gas cap is loose, damaged or missing. The gas cap for your 2013 Lexus IS 250C serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is erstwhile or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't costly. If your check engine light turns on immediately after you put gas in your 2013 Lexus IS 250C, first thing you should check is to make sure the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • The battery is low or dead. The battery in your 2013 Lexus IS 250C is every instinctive. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did countless decades ago, and they don't certainly require maintenance. The price of a new one depends on the type of Lexus you drive, but check our modern service coupons and specials.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, noted as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be fewer productive when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2013 Lexus IS 250C's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to read the right mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or alternative item can wreak havoc on your 2013 Lexus IS 250C if it’s not installed properly. These aftermarket parts and accessories can drain the battery, trigger the check engine light, or even prevent the vehicle from starting. If these issues sound affectionate, bring your IS 250C to Lexus and have our team of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, especially aftermarket parts and accessories, or using OEM parts first place might cost a little bit more but could save you money from having to get scanty work and damage caused by scanty installation work corrected.
  • Your 2013 Lexus IS 250C has a vacuum leak. Every Lexus IS 250C has a vacuum system that performs a expanded variety of functions. The vacuum system also helps lower harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, especially if they’re exposed to exciting heat or extreme chilly.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Lexus IS 250C is what determines how much fuel is imperative to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to confident changes, like altitude. If your Lexus IS 250C is having trouble starting, idling rough or has a sudden change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.

2013 Lexus IS 250C Check Engine Light Flashing

Although there are copious ability causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are numerous aware causes including something as simple as a loose gas cap. Other aware reasons for a Check Engine Light are faulty emissions control part, dirty mass airflow sensor, a malfunction with the fuel injection system, damaged oxygen sensor, faulty head gasket, or defective spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Lexus Certified Technicians and the certified service protocol to isolate the root problem and repair it as mandatory to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Lexus issue was fixed.

Every 2013 Lexus IS 250C was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the car on its laborious systems. The sensors are continually detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light lights up telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is amiss nor what to do about it. That’s where we come in; Plaza Lexus provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Immensely Qualified Service professional.

How many miles can you drive with the check engine light?

If you check engine light is flashing, we endorse that you pull over and contact Plaza Lexus to help represent if your vehicle is safe to commute in or if we endorse a tow truck. The safest bet is to decipher the code and then plan your strategy accordingly. Since each check engine code has its own level of severity, it is laborious to predict how frequent miles you can commute with the warning light on. It could be anything from a bad sensor to plug wires needing to be replaced.

Is it safe to drive your 2013 Lexus IS 250C with the check engine light on?

This question is not very easy because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to travel to work. This is usually indicated by a steady glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more tough problem. If the check engine light is flashing, this means that there is a tough issue and it is recommended to service your Lexus IS 250C swiftly. Call the advisors at Plaza Lexus by dialing 3145823688 so you can describe the issues. Or reduce your speed and bring your 2013 Lexus to our certified mechanics as soon as feasible.

What Does the Check Engine Light Mean?

One of the most commonly misunderstood lights or indicators in your 2013 Lexus IS 250C is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few definite ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your 2013 Lexus IS 250C. Some of these include shifting automatic transmissions ignition timing, controlling engine speed, and implementing stability control, just to name assorted. With that being said, the check engine light can learn a mixture of odd things. It can be as simple as your gas cap being loose or as perilous as engine knocking. If your check engine light is on in your 2013 Lexus IS 250C, contact Plaza Lexus. Contact Plaza Lexus today! Our Lexus service department can help you designate what code is turning your check engine light on or diagnose why your check engine light is twinkling.